Overview - Coolant Pump/Coolant Thermostat: Notes
WARNING: This page is about a different variant/trim than selected.
- Connection
- O-ring
- Always replace after removing.
- Coat with coolant
- Centering Pin
- Bolt
- Tightening Specifications and Sequence. Refer to Figure.
- Seal
- Always replace after removing.
- Coolant Pump
- Removing and installing. Refer to COOLANT PUMP, REMOVING AND INSTALLING .
- For a new coolant pump, remove the protective cap
- Bolt
- Tightening sequence. Refer to Figure.
- Toothed Belt
- For the coolant pump
- Removing and installing. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Toothed Belt Guard
- Bolt
- 10 Nm + 90°
- Always replace after removing.
- Left-hand thread
- Toothed Belt Sprocket
- Note the installation position
- Seal
- Replacing. Refer to the appropriate service information. .
- For the intake side balance shaft
- Intake Side Balance Shaft
- Seal
- Always replace after removing.
- Engine Temperature Control Actuator -N493-
- Removing and installing. Refer to Engine Temperature Control Actuator -N493-, REMOVING AND INSTALLING .
- Perform the adaptation after replacing using the Vehicle Diagnostic Tester