Coolant Pump, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install In Reverse Order Of Removal and Note The Following:
- Used coolant cannot be used again.
-- Install the coolant pump -1- and toothed belt.
-- Pay attention that the centering piece -arrows- and seal -3- are seated correctly.
-- Tighten the coolant pump bolts. Refer to Figure.
-- After installing a new coolant pump -2-, remove the protective cap -1- from the drive wheel.
-- Fill with coolant. Refer to COOLANT, FILLING .
Additional procedures. Refer to BLEED COOLING SYSTEM and COOLANT LEVEL, CHECKING (COOLANT PUMP, REMOVING AND INSTALLING ) .