Coolant Pump Toothed Belt, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
Required preliminary procedure descriptions. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .
-- If installed, remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Disconnect the connector -1- from the Oil Pressure Switch, Level 3 -F447- -2-.
-- Remove the bolts -arrows- and remove the toothed belt guard.
-- To do so counterhold the crankshaft on the vibration damper with the :T40263 , :T40314 and the 24 mm socket.
TIP:
The Drive Wheel Bolt Has Left-Hand Thread.
-- Counterhold the vibration damper and remove the bolt on the drive wheel -1- for the coolant pump and loosen three turns -arrow-. Use :VAG1410 and :T10360 .
-- Remove the toothed belt -2-.