Catalytic Converter, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
NOTE:
When Installing, Bring All Cable Ties Back To Same Positions.
-- Remove the front muffler. Refer to FRONT MUFFLER, REMOVING AND INSTALLING .
-- Remove the nut -2- from below.
NOTE:
The nuts -1- will be removed later.
-- Disconnect the connector -1- on the Oxygen Sensor after Three Way Catalytic Converter -G130- -2- and free up the wire.
-- Remove the nut -1- from above and remove the catalytic converter from above.