Overview - Emissions Control System
WARNING: This page is about a different variant/trim than selected.
Fig 1: Exploded View Of Emissions Control System (CYMC, CYRB, CYRC, CWPB, DAXB, DAXC, CJEB, CJED, CJEE, CNCD, CNCE, CUHA, CUJA, CNCB, CUHB, DAYB, CYGA, CYNB, CYPA, CYPB, CYYA & CVJA)
- Seal
- Always replace after removing.
- Turbocharger
- Heated Oxygen Sensor -G39- and Oxygen Sensor Heater -Z19-
- Removing and installing. Refer to HEATED OXYGEN SENSOR, REMOVING AND INSTALLING .
- Nut
- 40 Nm
- Always replace after removing.
- Coat turbocharger stud bolts with hot bolt paste.
- Hot bolt paste. Refer to the parts information.
- Oxygen Sensor after Catalytic Converter -G130- and Heater for Oxygen Sensor 1 after Catalytic Converter -Z29-
- Removing and installing. Refer to HEATED OXYGEN SENSOR, REMOVING AND INSTALLING .
- Catalytic Converter
- Protect catalytic converter from shocks and impact stress
- Removing and installing. Refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING [CYNB ENGINES] .
- Exhaust System, Installing without Tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .