Removal And Installation

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

All brackets

1.

Remove the Power Running Board(PRB) step. For additional information, refer to Power Running Board (PRB) Step .

Front bracket - regular wagon

2.

NOTE: The PRB motor is part of the front bracket assembly.

Disconnect the PRB motor electrical connector.

Courtesy of FORD MOTOR COMPANY

3.

NOTE: Only 3 bolts shown.

Remove the PRB front bracket 2 upper and 2 lower bolts and the front bracket assembly.
- To install, tighten to 23 Nm (17 lb-ft).

Courtesy of FORD MOTOR COMPANY

Rear bracket - regular wagon

4.

Remove the PRB rear bracket 2 upper and 2 lower bolts and the rear bracket assembly.
- To install, tighten to 23 Nm (17 lb-ft).

Courtesy of FORD MOTOR COMPANY

Extended wagon

5.

NOTE: An assistant is required to hold the Power Running Board(PRB) bracket assembly prior to removing the bolts. Failure to follow this instruction may result in damage to the component.

Remove the 4 front and rear bracket upper and lower bolts.
- To install, tighten to 23 Nm (17 lb-ft).

All brackets

6.

To install, reverse the removal procedure.