LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A6 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 136 (Supplemental Restraint System (Diagnostics - Introduction)) >> Airbag System >> Data List / Active Test [08/2013 - ] >> Data List / Active Test [08/2013 - ]

Data List / Active Test [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

HINT: 

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. DATA LIST FOR AIRBAG SENSOR ASSEMBLY 
    1. Turn the power switch off.
    2. Connect the Techstream to the DLC3.
    3. Turn the power switch on (IG).
    4. Turn the Techstream on.
    5. Enter the following menus: Body Electrical / SRS Airbag / Data List.
    6. Check the values by referring to the table below.
      SRS AIRBAG

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Driver Seat Position Driver Seat Position/
      Forward: Seat position is forward
      Bkward: Seat position is backward
      Fail: Failure detected      		 Forward/Bkward -
      Passenger Classification* Passenger Classification/
      NG: Data is not determined
      Child: Child is seated or Vacant
      AF05: Adult is seated
      AM50: Adult is seated
      Fail: A failure is detected      		 Child/AF05/AM50 -
      Left side Buckle SW Driver Side Buckle SW/
      Unset: The seat belt is not fastened
      Set: The seat belt is fastened
      NG: Data is not determined      		 Unset/Set -
      Right side Buckle SW* Front Passenger Side Buckle SW/
      Unset: The seat belt is not fastened
      Set: The seat belt is fastened
      NG: Data is not determined      		 Unset/Set -
      Display Type Information Display Type Information/
      LR: The display is indicated by LH/RH
      DP: The display is indicated by Driver/Passenger      		 LR -
      Number of Past DTC Number of Past DTC/
      Min.: 0, Max.: 255      		 0 -

      *: w/ Occupant Classification System

scientia non olet · About LEMON Manuals