Overview - Supercharger
- Supercharger
- With charge air coolers
- Supercharger, removing and installing. Refer to SUPERCHARGER, REMOVING AND INSTALLING .
- Overview - Charge Air Cooler. Refer to OVERVIEW - CHARGE AIR SYSTEM .
- Secured on the Engine and Gearbox Bracket:VAS6095A for repair work. Refer to SUPERCHARGER, SECURING TO ENGINE/TRANSMISSION HOLDER FOR REPAIR WORK .
- Secured on the Engine and Gearbox Bracket:VAS6095A for leak test. Refer to SUPERCHARGER, SECURING TO ENGINE/TRANSMISSION HOLDER FOR LEAK TEST .
- Ball Pin
- 5 Nm
- For engine cover
- Insulation Plate
- Bolt
- 5 Nm
- O-rings
- Replace after removing
- Bolt
- Tightening specification. Refer to TIGHTENING SPECIFICATIONS .
- Throttle Valve Control Module -J338-
- Removing and installing. Refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .
- Intermediate Flange
- O-rings
- Replace after removing
- Bolt
- Tightening specification and sequence. Refer to TIGHTENING SPECIFICATIONS .
- Intermediate Flange
- Control Valve Control Unit -J808-
- Removing and installing. Refer to Control Valve Control Unit -J808-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Bracket
- For change-over valves
- Connection
- Bolt
- Tightening specification and sequence. Refer to Tightening Specifications .
- O-ring
- Replace after removing
- Bolt
- 10 Nm
- Intake Air Temperature Sensor -G42- / Manifold Absolute Pressure Sensor -G71-
- Removing and installing. Refer to Intake Air Temperature Sensor -G42- /Manifold Absolute Pressure Sensor -G71-, REMOVING AND INSTALLING .
- O-ring
- Replace after removing
- Bleeder Screw
- 1.5 to 3.0 Nm
- For the charge air cooler
- Seal
- Replace after removing
- Nut
- 20 Nm
- Charge Air Pressure Sensor
- Cylinder bank 1 (right) Charge Air Pressure Sensor -G31-
- Cylinder bank 2 (left) Charge Air Pressure Sensor 2 -G447-
- Removing and installing. Refer to CHARGE AIR PRESSURE SENSOR - G31- / -G447-, REMOVING AND INSTALLING .
- Bolt
- 10 Nm
- O-ring
- Replace after removing
- Stud Bolt
- 17 Nm
- Connection
- For the crankcase ventilation
- Installed position. Refer to appropriate service information.
- Seals
- Replace after removing
- O-rings
- Quantity 2 each
- Replace after removing
- Engine Lifting Eye
- Bolt
- 27 Nm
- O-ring
- Replace after removing
- Turbocharger Speed Sensor 1 -G688-
- Removing and installing. Refer to Turbocharger Speed Sensor 1 -G688-, REMOVING AND INSTALLING .
- The opening cannot be used as an oil level display
- Bolt
- 10 Nm