Operating Head, Removing And Installing: Removing
- Supercharger secured to engine/transmission holder for repair work. Refer to SUPERCHARGER, SECURING TO ENGINE/TRANSMISSION HOLDER FOR REPAIR WORK .
-- Remove the solenoid coupling. Refer to SOLENOID COUPLING, REMOVING AND INSTALLING .
-- Hold the supercharger perpendicular on the engine/transmission holder.
- The drive head faces up.
-- Remove the coil spring -1- from driveshaft -2-.
-- Remove the bolts -arrows-.
CAUTION:
- To prevent the rotor unit bearing cap -1- from coming and loose and having to be sealed again, do not use a hammer to remove the drive head -2- but rather use expanding pliers in direction of -arrows-, as illustrated.
-- Carefully remove the operating head with expanding pliers from the bearing cap.
-- Extract all the oil for the supercharger drive from the bearing cap as well as from the oil pockets -arrows- between the ribs using the :SMN372500 .