Overview - Gear Set, AWD Vehicles: Notes

Fig 1: Exploded View Of Gear Set, AWD Vehicles (0CK, 0CJA, 0CLA, 0DN & 0DPA)

Courtesy of AUDI OF AMERICA, LLC

Oil Pipe
Bolt
- 3 Nm + 90°
- Always replace
- M6 X 30
Gear Positioner with:
- Transmission Input Speed Sensor 1 -G632-
- Transmission Input Speed Sensor 2 -G612-
- Gear Position Distance Sensor 1 -G487-
- Gear Position Distance Sensor 2 -G488-
- Gear Position Distance Sensor 3 -G489-
- Gear Position Distance Sensor 4 -G490-
- Removing an installing. Refer to GEAR ACTUATOR MODULE AND HYDRAULIC PRESSURE RESERVOIR, REMOVING AND INSTALLING .
- Observe the tightening sequence. Refer to Figure.
Seal
- Replacing
Oil Pan
- Replacing
Bolts
- 3 Nm + 90°
- Always replace
- M6 X 30
Needle Bearing
Seal
- Always replace
Hydraulic Pressure Reservoir
- Observe the safety notes. Refer to ATF PUMP, DEACTIVATING AND DRAINING THE HYDRAULIC PUMP RESERVOIR .
- Removing an installing. Refer to GEAR ACTUATOR MODULE AND HYDRAULIC PRESSURE RESERVOIR, REMOVING AND INSTALLING .
- Disposal. Refer to HYDRAULIC PRESSURE RESERVOIR, DISPOSING .
- Observe the tightening sequence. Refer to Figure.
Bolts
- Always replace
- Observe the tightening sequence. Refer to Figure.
Bearing Bracket with Roller Bearing
- Observe the tightening sequence. Refer to Figure.
Gear Set
- Removing and installing. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .
Needle Bearing
Bolts
- 6 Nm + 30°
- Gearshift rail gear positioner module
- M6 X 50