Overview - Transmission Fluid Circuit

Fig 1: Transmission Fluid Circuit Components Location (0CK, 0CJA, 0CLA, 0DN & 0DPA)

Courtesy of AUDI OF AMERICA, LLC

Plug
- 8 Nm +30°
- Replace after removing.
- For the ATF check and fill hole
Plug
- 35 Nm
- Replace after removing.
- For transmission fluid inspection and fill hole
Transmission Fluid Pump (MTF Pump)
- With seal welded on
- Must be removed for draining the transmission fluid (MTF).
- Replace the transmission fluid pump if the seal is damaged.
- Removing And Installing. Refer to TRANSMISSION FLUID PUMP, REMOVING AND INSTALLING [FOR ENGINE(S) CYNB, CPNB] .
Bolt
- 3 Nm +90°
- Replace after removing.
Drain Plug
- 35 Nm
- Replace after removing.
- For the ATF