Securing On Engine And Transmission Holder
Special Tools And Workshop Equipment Required
- Shop Crane :VAS6100
- Engine and Gearbox Bracket :VAS6095A
- Engine/Gearbox Support Shackle (2 pc.) :10-222A/12
- Gearbox Support :T40206 and Gearbox Support - Drilling Template :T40206/3
- Retaining Strap :T40155
- Lifting Eyebolt :3368
PROCEDURE
-- Assemble the :T40206 as follows:
- The connection area -arrow A- points upward.
- The lettering "B" points upward -arrow B-.
-- Place the :T40206/3 on the : T40206 .
-- Make an additional 12 mm hole -arrow- in the :T40206 .
-- Install the bolts as follows in the holes:
- M10x80 in the hole 15
- M10x120 in the hole 11
- M10x80 in the hole 7
- M10x50 in the new hole 5b
Risk Of Damaging The Transmission By Mixing ATF And Transmission Fluid (MTF) Through The Same Bleeder.
- The ATF and transmission fluid must be drained.
-- Draining the ATF. Refer to ATF, DRAINING AND FILLING .
-- Draining the transmission fluid. Refer to TRANSMISSION FLUID, DRAINING AND FILLING [FOR ENGINE(S) CYNB, CPNB] .
-- Secure the :3368 with the :10-222A/12 on the transmission housing as shown.
-- Secure the :T40155 on the :10-222A/12 and on the left flange shaft -arrow-.
-- Lift the transmission with the :VAS6100 and secure on the :T40206 as shown.