Transmission Control Module -J217-, Removing And Installing: Installing: Notes

Install In The Reverse Order Of Removal While Noting The Following:

NOTE:

Before Installing Clean The Control Module Threaded Holes Of Oil And Debris.

-- Push the control module evenly on the valve body and tighten the bolts in the sequence -1 to 4- to the tightening specification.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

A Protector Is Located On The ATF Pump.

Courtesy of AUDI OF AMERICA, LLC

Pay attention to the correct assembly.

-- Push in the sensor arm -1- on the ATF pump -2- by hand and tighten the bolts -arrows- hand-tight.

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

There Is A Risk Of Damaging The ATF Pump.

-- Tighten the bolts to the specification in the following sequence: -1 through 3-.

Fig 1: Sensor Arm Bolts Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Install the cover -1- for the sensor arm -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Install the Hydraulic Pressure Sensor 1 -G545- and Hydraulic Pressure Sensor 2 -G546-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Do Not Switch The Connectors,

Make sure that the connection is correct as shown -1 and 2-.

-- Install the Mechatronic. Refer to MECHATRONIC, REMOVING AND INSTALLING .