Overview - Timing Chain Cover: Notes
Courtesy of AUDI OF AMERICA, LLC
- O-ring
- Always replace after removing.
- Coat with oil before assembly
- Oil Dipstick Tube
- Clipped in on the upper timing chain cover
- Bolt
- Left Coolant Pipe
- Bolt
- Tightening sequence. Refer to Figure.
- Bolt
- Steel bolt 9 Nm
- Aluminum bolt 4 Nm + 45°
- Always replace the aluminum bolt after removal
- Cam Adjustment Valve 1 -N205-
- Bolt
- Steel bolt 9 Nm
- Aluminum bolt 4 Nm + 45°
- Always replace the aluminum bolt after removal
- Exhaust Cam Adjustment Valve 1 -N318-
- Seals
- Always replace after removing.
- Installation position: smaller inner diameter outward
- Remove to replace the upper timing chain cover -item 13- OVERVIEW - TIMING CHAIN COVER
- Coat with oil before assembly
- Seal
- Always replace if damaged
- Cap
- Upper Timing Chain Cover
- Seal
- Always replace if damaged
- O-rings
- Always replace after removing.
- Coat with engine oil
- Alignment Pin
- For centering the cover
- Quantity: 2
- Bolt
- Tightening specification and sequence with 15 bolts. Refer to Figure.
- Tightening specification and sequence with 8 bolts.
.
- Always replace after removing.
- Lower Timing Chain Cover
- Seal
- Plugs
- Always replace after removing.