ENGINE, SECURING TO Engine and Transmission Holder: VAS6095A
Special tools and workshop equipment required
- Engine Sling: 2024A
- Holding Fixture: VW540
- Shop Crane: VAS6100
- Engine and Transmission Holder: VAS6095A
Procedure
- Engine engaged with the : 2024A on the : VAS6100
- To be aligned to the center of gravity of the assembly, the rails with holes of the lifting hooks must be inserted as shown.
CAUTION:
There is a risk of injury from the lifted engine falling.
Parts of the body could be crushed.
- Secure the mounting hooks and pins on the lifting tackle with a securing pin.
-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
-- Tighten the : VW540 on the transmission side as shown on the engine with the bolts -arrows- and nut -2-.
-- Secure the : VW540 with mounting pin -3- and cotter pin -1- on the : VAS6095A .
Assembling
Assemble in the reverse order of removal. Note the following:
-- Install the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .