Undamaged Side Window, Removing, A5 SPORTBACK

• Pay attention to the repair information. Refer to REPAIR INFORMATION .

PROCEDURE 

-- Remove the C-pillar trim panel. Refer to C-PILLAR TRIM PANEL, REMOVING AND INSTALLING .

-- Remove the D-pillar trim panel. Refer to D-PILLAR TRIM PANEL, REMOVING AND INSTALLING .

-- Remove the door seal in the side window area.

-- Insert a cutting guard from the :861 001A  inside between the cutting wire and trim panels.

-- Pull the :VAS861 001/1A  with the threading tool -1- under the trim molding -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Place the :VAS861 001/1A  all around under the side window seal and secure on the end of the striker -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Secure the upper side window using adhesive tape -1-.

-- Insert the free end of the :VAS861 001/1A  in the piercing awl -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

TIP:

To prevent any damage, cover the entry zone of the piercing awl at the body flange with adhesive tape -arrow-.

-- Press the piercing awl in this area from the outside inward through the adhesive bead and pull the cutting cord inward.

-- Secure the removal device -1- with the reel device on the inside of the window.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push the : VAS861 001/1A  in the reel device and direct it over the hook -2-.

-- Tension the cutting cord with the reel device.

-- Cut the first section free. This will guide the cutting wire into the integrated idler roller on the reel device.

-- Offset the hook -2- and cut free the bottom of the rear side window using the removal device -1-. The locating pins are cut at the same time.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Offset the hook -2- and cut free the rear area of the rear side window using the removal device -1-. The locating pins are cut at the same time.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the hook and cut free the upper area on the D-pillar using the removal device -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Insert the hook -2- in the hole under the side window and cut free the upper end of the side window using the removal device -1-. The locating pins are cut at the same time.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the side window carefully toward the rear from the roof trim molding connecting piece and remove.