4.3 Lane Change Assistance Control Modules -J769-/-J770-, Removing and Installing

Removing 

• Remove the rear bumper cover. Refer to → Rear Bumper; Bumper Cover, Removing and Installing
• Release the catch -3- and tilt the control module -2- out in the direction of -arrow-.
• Disengage and remove the control module from the lower mount -4-.
• Disconnect the connector -1-.

Installing 

Install in reverse order of removal and note the following:

• Calibrate the Lane Change Assistance Control Modules - J769-/-J770-. Refer to 4.4 Lane Change Assistance, Calibrating