Crimping Inner Conductor

Courtesy of AUDI OF AMERICA, LLC

-- Select the appropriate tool head based on the antenna wire test. Refer to CHECKING THE ANTENNA WIRE  or REPLACING TOOL HEAD .

-- Unfold the positioner -2-.

-- Open the positioning plate -3-. The positioning plate swivels upward.

-- Push the inner contact -1- all the way into the positioner and loosen the positioning plate. The inner contact is attached.

-- Fold the positioner back in. The inner contact -4- is positioned inside the tool head.

Courtesy of AUDI OF AMERICA, LLC

-- Slide the antenna wire -1- into the inner contact -2- in the tool head. Hold the positioner tight while doing this.

-- Lock the tool until it opens by itself.

-- Open the positioning plate -3- and pull out the antenna wire.