Fiber-Optic Cable, Preparing With The Fiber-Optic Conductor Repair Set : Vas6223A: Stripping

Courtesy of AUDI OF AMERICA, LLC

-- Open the : VAS6223/1  .

• Stripping lever must be in lower position -arrow-.

-- Place the fiber optic cable -1- in the stripping point.

• The end of the fiber-optic cable must be flush with the rear side of the cutting pliers.

-- Close : VAS6223/1  until stop and keep closed.

Courtesy of AUDI OF AMERICA, LLC

-- Lift the stripping lever -arrow- upward.

-- Open the cutting tool and take out the fiber-optic cable -1-.

-- Detach the separated section of the insulation from the fiber-optic cable.

Precision Cutting (production of optical end face)

Courtesy of AUDI OF AMERICA, LLC

-- Slide the fiber-optic cable -1- into the cutting station.

• The insulation must make contact with the cutting point stop -arrow-.

-- Close the : VAS6223/1  .

-- Press the cutting unit down -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Open : VAS6223/1  and remove fiber-optic cable -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Open the : VAS6223/1  .

-- Position the wire stripper in the lower position -arrow-.

-- Insert fiber-optic cable into the stripping station.

• The end of the fiber-optic cable must be flush with the rear side of the cutting pliers.

-- Close the : VAS6223/1  until the stop and keep closed.

Courtesy of AUDI OF AMERICA, LLC

-- Bend the wire stripper upward -arrow- and remove the fiber-optic cable.

Precision Cutting (production of optical end face).

Courtesy of AUDI OF AMERICA, LLC

-- Push the fiber-optic cable -1- into the cutting station.

• Insulation must make contact with cutting point stop.

-- Close the : VAS6223/1  and remove the wire.

Courtesy of AUDI OF AMERICA, LLC

-- Visually inspect the wire -1- to make sure that it was cut correctly and that there are no burrs on the front surface.