Attaching Brass Pin Contact To Fiber-Optic Cable

Courtesy of AUDI OF AMERICA, LLC

-- Open securing lever on : VAS6223/2  -arrow 1- and -arrow 2-.

-- Insert brass pin contact -1- in the mount.

Courtesy of AUDI OF AMERICA, LLC

-- Close the safety lever on the : VAS6223/2  -arrow-.

-- Slide the fiber optic cable -2- into the brass pin contact -1- as far as spring-loaded stop.

Courtesy of AUDI OF AMERICA, LLC

-- Slide fiber-optic cable further in up to fixed stop and close : VAS6223/2  .

-- Open the crimping pliers for fiber-optic cable and remove the fiber-optic cable with the brass pin contact.

-- Make sure the brass pin contact -2- is secured correctly on the fiber-optic cable -1-.

Courtesy of AUDI OF AMERICA, LLC

• Four crimp points must be visible at the brass connection pin.
• The brass pin contact must not be able to be removed by hand from the fiber-optic cable.
• The front surface of the fiber-optic cable is 0.01 to 0.1 mm behind the brass pin contact (visual check).

Courtesy of AUDI OF AMERICA, LLC

-- Change tool head -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Slide the safeguard on the : VAS6223/1  -arrow- so that the word "Stift" (pin) is legible.

-- Insert a brass pin contact -1- in the mount.

Courtesy of AUDI OF AMERICA, LLC

-- Close the securing lever on the : VAS6223/1  -arrow-.

-- Insert the fiber-optic cable into the brass pin contact -arrow- all the way up to the threaded stop and then close the : VAS6223/1  .

Courtesy of AUDI OF AMERICA, LLC

-- Open the fiber-optic cable pliers and remove the fiber-optic cable along with the brass contact pin.

-- Make sure the brass pin contact -2- is secured properly on the fiber-optic cable -1-.

Courtesy of AUDI OF AMERICA, LLC

• 4 crimped points must be visible on the brass connecting pin.
• The brass pin contact must not be able to be removed by hand from fiber-optic cable.
• The front surface of the fiber-optic cable is 0.01 to 0.1 mm behind the brass pin contact (visual check).