Bleeding Sequence

1. Left front outer brake caliper (not steel brakes 1LA/1LB)
2. Left front inner brake caliper
3. Right front outer brake caliper (not steel brakes 1LA/1LB)
4. Right front inner brake caliper
5. Left Rear Brake Caliper
6. Right Rear Brake Caliper

-- Leave the bleed screw open with the brake fluid hose connected, until brake fluid flows out clear and without air bubbles.

-- Press brake pedal five times to assist the bleeding procedure.

-- Tighten the bleed screw, remove the bleeder hose and place the dust cap on the bleed screw.

-- Repeat the bleeding procedure in the specified sequence for the remaining brake calipers.

-- Fill the brake fluid reservoir under consideration of brake pad wear up to the "MAX" mark and screw on the fuel cap.

Fig 1: Brake Fluid Reservoir

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

• Do not add brake fluid above the "MAX" mark otherwise it will leak out of the reservoir.

-- Start the engine and check the brake pedal travel and pressure.

-- If the pedal travel is too long, check the brake system for leaks or repeat the bleeding procedure.

• A road test must be performed after bleeding. While doing so, at least one ABS control must be performed at all four wheels.

Brake Fluid, Changing. Refer to appropriate service information.