Position The Spoiler -2- On The Rear Lid -3- Using A Second Technician.

Courtesy of AUDI OF AMERICA, LLC

• Position the spoiler in the center with the :T40377/1  .
• Position the left spoiler on the outer edge using the :T40377/2  .
• Position the right spoiler on the outer edge using the :T40377/3  .
• Mark the position of the spoiler with spacers -1-.

-- Clean the adhesive surface from the adhesive tape on the body with Cleaning Solution: D 009 401 04  and let it dry.

-- Clean the adhesive surface on the spoiler with Cleaning Solution: D 009 401 04  and let it dry.

-- Fold back the end of the protective film, or attach a pulling aid -1- to the protective film.

Courtesy of AUDI OF AMERICA, LLC

-- Apply an adhesive bead of One-Part MS Assembly Adhesive:D 172 090 A2  centered in the adhesive bed over the entire area to be riveted on the spoiler -2-.

• Dimension -a- = 5 mm ± 1.5 mm
• Dimension -b- = 4 mm ± 1 mm

-- Position the spoiler -4- according to the spacers -2- applied on the rear lid -3- and align to the side.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the protective film on the removal aid -1- from the inside outward.

-- Press on the spoiler first on the outer edge and then on the inner edge over the entire length.

• Vehicle resting time is at least 24 hours at room temperature.