General Information - Name Badges And Emblems, Replacing

Special Tools And Workshop Equipment Required 

• Roller:3356 
• Cleaning Solution:D 009 401 04 
• Bonding Agent:D 355 205 A2 
• Applicator:D 009 500 25 

• Loosened name badges and emblems must be replaced.
• The vehicle as well as the name badges and emblems must be at room temperature.
• The adhesive surfaces must be free of dirt and grease.

-- Remove adhesive residue from the body.

-- Clean the painted side of the adhesive surface with Cleaning Solution:D 009 401 04  and let dry.

-- Apply Bonding Agent:D 355 205 A2  -item 1- on the painted side of the adhesive surface -2- using the Applicator:D 009 500 25  -item 3- and let it dry for ten minutes.

Fig 1: Applying Bonding Agent To Adhesive Surface On Paint Side Using Applicator

Courtesy of AUDI OF AMERICA, LLC

• If the Bonding Agent:D 355 205 A2  dries longer than two hours, then it must be primed again.

-- Warm the adhesive areas to approximately 40 °C using a hot air blower.

• Neighboring components must be protected against temperature effects.

-- After successfully assembling, press on the emblems again with the roller.

• Vehicle Resting Time Is At Least 30 Minutes At Room Temperature.