Self-Adhesive Sunroof Seals, Removing And Installing:

REMOVING 

-- Open the glass panel far enough until it is lifted at the front and rear.

-- Remove the seal. If necessary, also warm it up using the :VAS1978/14A  .

INSTALLING 

Install in reverse order of removal and Note The Following: 

• The vehicle and the seal must be at room temperature.
• The adhesive surfaces must be free of dirt and grease.
• Do not stretch the seal when installing it.

-- Remove adhesive residue from the body.

-- Clean the adhesive surface with Cleaning Solution:D 009 401 04  and let dry.

-- Remove the protective film from adhesive tape.

-- Position the seal and press on along the entire length.

• Vehicle resting time is at least 30 minutes at room temperature.