Convertible Top Drive Hydraulic Cylinder, Removing And Installing: Removing
-- Remove the convertible top. Refer to CONVERTIBLE TOP, REMOVING AND INSTALLING .
-- Release the clamp -4- and remove the retaining pin -1 and 3-.
-- Remove the hydraulic cylinder -2- from the main bearing.
If The Hydraulic Cylinder Is Being Replaced:
- Hydraulic Line, Removing. Refer to HYDRAULIC LINE ON CYLINDER, REMOVING AND INSTALLING .
- Left hydraulic cylinder: free up the wiring harness and remove the Convertible Top Stowed Position Switch -F171- / Convertible Top Front Closed Position Switch -F202-. Refer to CONVERTIBLE TOP OPEN POSITION SWITCH -F171- /CONVERTIBLE TOP FRONT CLOSED POSITION SWITCH -F202-, REMOVING AND INSTALLING .