Side And Height Adjustment At Striker: Procedure

SIDE ADJUSTMENT AT STRIKER 

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Loosen the nuts -1, 3 and 4-.

-- Move the striker -2-.

• During the closing test, the hood must fall from the balance position into the latch and engage completely.

-- Tighten the nuts.

TIGHTENING SPECIFICATIONS 

• Refer to OVERVIEW - HOOD 

HEIGHT ADJUSTMENT AT STRIKER 

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the adjusting buffer completely. Refer to HEIGHT, ADJUSTING USING ADJUSTING BUFFER .

-- Adjust the striker -2- by turning the adjusting screw -1- -arrows-.

• During the closing test, the hood must fall from the balance position into the latch and engage completely.

-- Adjust the striker height if necessary.