Bumper Cover Trim Molding, Removing And Installing, RS4 And RS5: Removing
-- Remove the bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .
-- Release the catches -arrows- and remove the side trim molding -1- from the lower section of the bumper cover -2-.
-- Release the catches -arrows- and remove the center trim molding -1- from the lower section of the bumper cover -2-.
TIP:
If the trim molding cannot be removed as described, then the bumper cover lower section must be removed. Refer to BUMPER COVER LOWER SECTION, REMOVING AND INSTALLING .