Overview - Impact Member: Notes
- Molded Foam Part
- Market-Specific Version
- Removing and Installing. Refer to MOLDED FOAM PART, REMOVING AND INSTALLING .
- Bracket
- For Outside Air Temperature Sensor -G17-
- Bolt
- 2.5 Nm
- Depending on the version
- Outside Air Temperature Sensor -G17-
- Removing and Installing. Refer to OUTSIDE AIR TEMPERATURE SENSOR -G17-, REMOVING AND INSTALLING .
- Impact Member
- Removing and Installing. Refer to IMPACT MEMBER, REMOVING AND INSTALLING .
- Bolt
- 55 Nm
- Quantity: 4
- Lock Carrier
- Bolt
- Quantity: 2
- Tightening specification Figure
- Bolt
- 14 Nm
- For securing the impact member to the lock carrier
- Quantity: 2
- Nut
- Tightening specification. Refer to OVERVIEW - HORN .
- Bracket with Horn
- Removing and Installing. Refer to OVERVIEW - HORN .
- Impact Member Mount
- Removing and Installing. Refer to IMPACT MEMBER, REMOVING AND INSTALLING .
- Connecting Brace
- Market-Specific Version
- Bolt
- 9 Nm
- Quantity: 2
- Nut
- Quantity: 2
- Driver Side Pedestrian Protection Crash Sensor 2 -G851- /Front Passenger Side Pedestrian Protection Crash Sensor 2 -G852-
- Unit with pressure hose
- Must be replaced when
- The molded foam part is visibly damaged.
- The impact member is visibly deformed.
- The bumper cover is deformed.
- The pressure hose is damaged.
- Removing and Installing. Refer to OVERVIEW - PEDESTRIAN PROTECTION / PEDESTRIAN PROTECTION CENTER CRASH SENSOR -G693-, REMOVING AND INSTALLING .