Lane Change Assistance, Calibrating: Procedure

Fig 1: Identifying Assistance Calibration Device VAS 6350/4 Components

Courtesy of AUDI OF AMERICA, LLC

-- Turn on the :VAS6350/4  at the power switch -3-.

• The green LED -1- must turn on.

-- If the red LED -2- turns on: Check the :VAS6350/4  .

-- Follow the instructions in the Vehicle Diagnostic Tester display.

During the program sequence, there is a prompt to switch the :VAS6350/4  from the left to the right side of the :VAS6350  .

Courtesy of AUDI OF AMERICA, LLC

-- Turn off the :VAS6350/4  and reposition the calibration tool.

• When installed correctly, the vehicle electrical system voltage wire must be connected at the bottom left of the calibration device (as seen in direction of travel).