Lane Change Assistance, Calibrating: Notes
Special Tools And Workshop Equipment Required
- Vehicle Diagnostic Tester
- Calibration Unit:VAS6350A
Conditions
-- The Lane Change Assistance Control Module -J769- / Lane Change Assistance Control Module 2 -J770- must be calibrated using the Vehicle Diagnostic Tester during the following conditions:
- Lane Change Assistance Control Module -J769- or Lane Change Assistance Control Module 2 -J770- was replaced.
- The rear bumper cover was damaged by a parking block, for example.
- The rear bumper cover was removed and installed.
- The threaded connections on the bumper mount are loosened.
- "No or incorrect basic setting/adaptation" is stored in the DTC memory.
Preparing For Calibration
- Calibration Tool - Spacing Laser:VAS6350/2
- For distance measurement
- Usage information. Refer to the Calibration Tool:VAS6350 Owner's Manual.
- Calibration Tool:VAS6350A
- Level
- On the :VAS6350A
- To check the horizontal position of the :VAS6350A
- Catch Bracket
- To mount the :VAS6350/2 for the distance measurement
- Distance to the :VAS6350/1 on the rear wheels: Dimension -a- = 1700 ± 2 mm
- Calibration Tool - Lane Change Calibration Tool:VAS6350/4
- Is moved from one side of the measuring field to the other during calibration
- When installed correctly, the vehicle electrical system voltage line must be connected at lower left of the calibration device (as seen in direction of travel)
- Brand Emblem
- The laser point is aligned to the center of the brand emblem
- Calibration Tool - Wheel Center Mountings:VAS6350/1
- With wheel bolt adapter and measuring paddle
- Measuring Scale
- For positioning the :VAS6350/4
- Calibration Tool - Linear Laser:VAS6350/3
- With "laser protective eyewear"
- On the :VAS6350A
- Switching on and off. Refer to :VAS6350A Owner's Manual.
- Plastic Foot
- Quantity: 3
- Can be adjusted when setting the horizontal position of the :VAS6350A