Calibrating Procedure

The Vehicle Diagnostic Tester is connected.

-- Select and start the Diagnostic  operating mode.

-- Select the Test plan  tab.

-- Select the Select individual test  button and select the following tree structure consecutively:

• Body
• Electrical system
• 01  - OBD-capable systems
• CF  - Lane Change Assistance Control Module 2 -J770
• CF  - Lane Change Assistance Control Module 2, Functions
• CF  - Calibration

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.

TIP: 

• The following information clarifies which version of the lane change assistance is installed in the vehicle (SWA3.0).
• This information for adjusting the calibration device is important for later steps in the procedure to avoid malfunctions.

-- Secure the :VAS6350/4  to the :VAS6350A  mount on the rear left.

Courtesy of AUDI OF AMERICA, LLC

• When installed correctly, the vehicle electrical system voltage wire must be connected at the bottom left of the calibration device (as seen in direction of travel).