Terminal 30 Wire Junction 3 -TV28-, Removing And Installing: Removing

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING, ENGINE COMPARTMENT BATTERY, G-TRON .

-- Release the retainers -arrows-.

-- Remove the engine control module -3- and with the lines -1- attached move to the side.

-- Free up the wiring harness -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -3 and 4- and the bolts -1-.

-- Remove the engine control module mount -2-.

-- Release the latch -arrow- and open the cover -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove and free up the wires -6 and 7-.

-- Remove the nut -5- and free up the wire -3-.

-- Remove the nuts -2 and 8-.

-- Remove the wire junction -4-.