Terminal 30 Wire Junction -TV2-, Removing And Installing: Removing
-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Remove the air filter housing. Refer to OVERVIEW - AIR FILTER HOUSING [4-Cylinder Direct Injection 2.0L 4V TFSI Engine] / AIR FILTER HOUSING, REMOVING AND INSTALLING [4-Cylinder Direct Injection 2.0L 4V TFSI Engine]AIR FILTER HOUSING, REMOVING AND INSTALLING [4-Cylinder Direct Injection 2.0L 4V TFSI Engine] or OVERVIEW - AIR FILTER HOUSING [4-Cylinder Direct Injection 2.0L 4V TFSI Engine] / AIR FILTER HOUSING, REMOVING AND INSTALLING [4-Cylinder Direct Injection 2.0L 4V TFSI Engine]AIR FILTER HOUSING, REMOVING AND INSTALLING [4-Cylinder Direct Injection 2.0L 4V TFSI Engine] .
-- Release the retainer -arrow-.
-- Open the cover -1-.
-- If equipped, remove terminal 30 wire junction 2 and move to the side with the wires still connected. Refer to TERMINAL 30 WIRE JUNCTION 2 -TV22- .
-- Disconnect the connector -5-.
-- Remove the nuts -2 and 3- and free up the wires -1 and 4-.
-- Remove the bolts -arrows-.
-- Remove the wire junction -6-.