Relay And Fuse Panel 4 -SR4-, Removing And Installing: Removing

-- Remove the right front sill panel. Refer to OVERVIEW - SILL PANEL .

-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING .

Courtesy of AUDI OF AMERICA, LLC

-- Push the carpet in the area of the footwell to the side as far as possible.

-- Release the catch -5- and open the cover -4- -arrow-.

-- Remove the nuts -1, 2 and 3- and free up the wires.

-- Remove the relay -2- from the mount -1- by opening the clip -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Release the retainer -arrow- and remove the wire junction -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Release the clips -arrows- and press the relay panel -2- back and out of the bracket -1-.

Fig 1: Identifying Relay Panel And Connector Station

Courtesy of AUDI OF AMERICA, LLC