Right And Left MULTIFUNCTION Buttons On Steering Wheel -E441- / -E440-, Removing And Installing, Steering Wheel With Round Airbag: Removing

-- Turn off the ignition and all electrical equipment and remove the ignition key.

-- Remove the driver airbag. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING / OVERVIEW - DRIVER SIDE AIRBAG .

-- Remove the connecting wires from the guides in the steering wheel.

-- Loosen the trim panel -2- with the multifunction buttons by hand -arrows- and remove it approximately 5 mm from the steering wheel -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release the multifunction buttons -2- with the :3409  next to the catches -3- (on the inside of the multifunction buttons). For this place the :3409  first on the top and then on the bottom of the multifunction buttons -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- While doing this, be careful of the connectors to the tiptronic switches -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release and disconnect the connector -2- from the multifunction buttons.

-- Remove the decorative trim with the multifunction buttons from the steering wheel.

The multifunction buttons are attached to the decorative trim.

-- Disconnect and remove the connector -3- from the multifunction button -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Open the clips -arrows- and push the multifunction button -1- out of the decorative trim -2-.

The additional wire on the right multifunction button remains on the button.