11.4 Front Parking Aid Sensor, Removing and Installing

Removing 

Exterior Sensors  :

• Remove the air intake grille. Refer to → Front Bumper
• Press both retainers to the side -arrows- and at the same time, push the sensor -3- through from the outside toward the inside.
• Disconnect the connector -2- by sliding the retainer -1- back and pressing the release down.

Interior Sensors  :

• Remove the front bumper cover. Refer to → Front Bumper; Bumper Cover, Removing and Installing
• Press both retainers to the side -arrows- and remove the sensor -2- from the mount -1- at the same time.

Installing 

Install in reverse order of removal.