Cigarette Lighter -U1-, Removing And Installing: Removing

-- Remove antenna 1 in the vehicle interior for the access/start authorization and set to the side with the wire still connected. Refer to ACCESS/START SYSTEM ANTENNA 1 IN VEHICLE INTERIOR -R138-, REMOVING AND INSTALLING

-- Disconnect the connector -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the lighter -2-

-- The release tabs -2- on the :T40148  must engage in the openings on the cigarette lighter -3- in the direction of -arrow-. To do so, the threaded rod -1- must be slid all the way down.

Fig 1: 12 V Socket 5 -U26-

Courtesy of AUDI OF AMERICA, LLC

-- Slide the :T40148  all the way into the cigarette lighter -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Turn the thumbwheel -2- on the :T40148  clockwise all the way to the end stop.

• The piston -2- is pulled upward and the release tabs -1- on the :T40148  spread in the direction of -arrows-.
  Fig 2: Identifying Release Tool T40148 In Use

  Courtesy of AUDI OF AMERICA, LLC

-- Remove the cigarette lighter from the illumination ring with the Socket Illumination Bulb -L42- using the :T40148  .

-- Guide the wire out through the mount.