Steering Gear, Servicing

Right Tie Rod End
- Check dust caps for damage and correct seating.
Nut
- 70 Nm
- Counterhold the nut on tie rod end using a wrench when loosening and tightening
Spring Clamp
Boot
- Removing and installing. Refer to BOOT, REMOVING AND INSTALLING .
- Check for damage
- Must not be twisted after toe is adjusted
Clamp
- Always replace if removed
- Install new clamp using Locking Pliers :VAS6199
Tie Rod
- 100 Nm
- If faulty, replace with tie rod end
- Removing and installing. Refer to TIE ROD, REMOVING AND INSTALLING .
Steering Gear Housing
Left Tie Rod End
- Check dust caps for damage and correct seating
Nut
- 70 Nm
- Counterhold the nut on tie rod end using a wrench when loosening and tightening
Spring Clamp
Boot
- Removing and installing. Refer to BOOT, REMOVING AND INSTALLING .
- Check for damage
- Must not be twisted after toe is adjusted
Clamp
- Always replace if removed
- Install new clamp using Locking Pliers :VAS6199
Tie Rod
- 100 Nm
- If faulty, replace with tie rod end
- Removing and installing. Refer to TIE ROD, REMOVING AND INSTALLING .