Headrest Cover And Cushion, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
-- Insert cushion -1- with proper fit in cover -2-.
-- Insert headrest support in the cushion with cover.
-- Close the main zipper by moving the upper cover flat channel -1- over the cover -2-.
-- Push the edge of the material with the flat channel into the U-channel -5-.
-- Push the side locks in the same way.
-- With a needle or pointed object, line up the cover and the channels.
-- Make sure the cover lies on the cushion -3- without any wrinkles and without seam markings.
Further installation is the reverse order of removal.