Brake Lamp Switch, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING [For engine(s) CRUA, DEJA] or ENGINE COVER, REMOVING AND INSTALLING [For engine(s) CNSB, CNTC] .
1.8L/2.0L TFSI Engine
-- Loosen the hose clamps -1 and 2- and remove the air guide pipe.
2.5L TFSI Engine
-- Loosen the hose clamps -arrows- and remove the air duct pipe.
2.0L TDI Engine
-- Expose the vacuum hoses -arrows-.
-- Loosen the hose clamps -1 and 2- and remove the air guide pipe.
Continuation for all Vehicles
-- Disconnect the connector -2-.
-- Remove the bolt -3-.
-- Remove the Brake Lamp Switch -F- -1- from the brake master cylinder.