LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A3 Premium, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 51 (Glass, Window Regulators -- (A3 Sedan)) >> 64 Glass, Window Regulators >> Rear Window >> Rear Window, Removing And Installing >> Undamaged Rear Window, Removing, A3 And SPORTBACK

Undamaged Rear Window, Removing, A3 And SPORTBACK

WARNING: This page is about a different variant/trim than selected.

-- Disconnect rear window defroster and window antenna connectors and secure to center of window with adhesive tape.

WARNING:

Risk of injury to the hands and eyes from glass fragments.

Getting cut is possible.

  • Wear protective eyewear.
  • Wear safety gloves.

-- Unroll with the :VAS6452/1  approximately 6.5 meters (7.1 yards) of cutting wire (approximately six turns) and cut it.

-- Poke the awl -2- through the bead of adhesive from the inside to the outside as illustrated.

-- Cover the area where the awl comes out under the body flange with adhesive tape -1- to prevent damaging it.

GWWA64-10376Courtesy of AUDI OF AMERICA, LLC

-- Feed both cutting wire ends -3- into the awl and pull it in.

-- Route the cutting wire around the rear window under the window glass as shown.

GWWA64-10377Courtesy of AUDI OF AMERICA, LLC

-- Mount both reel devices on the inside of the windshield as shown.

GWWA64-10378Courtesy of AUDI OF AMERICA, LLC

-- Insert an additional guide awl into the adhesive and secure it to the windshield with the suction cup as illustrated to make sure that the wire runs as close to the windshield as possible.

-- Insert the cutting wire end -1- into the reel device -2-.

GWWA64-10228Courtesy of AUDI OF AMERICA, LLC

-- Tension the cutting wire using the spool -1- and insert the plastic film -2- taken from the :VAS6452  to protect the wire and the rear shelf.

GWWA64-10291Courtesy of AUDI OF AMERICA, LLC

-- Cut the first section at the lower window edge free.

GWWA64-10379Courtesy of AUDI OF AMERICA, LLC

-- Cut out the window glass at the bottom of the >>D-pillar<<.

GWWA64-10380Courtesy of AUDI OF AMERICA, LLC

-- Position the guide ring as shown and cut upward farther in the area of the D-pillar.

-- Relocate the reel device and the guide awl as shown and cut out the section at the bottom of the opposite >>D-pillar<<.

GWWA64-10381Courtesy of AUDI OF AMERICA, LLC

-- Move the reel device as illustrated and install the guide awl.

GWWA64-10382Courtesy of AUDI OF AMERICA, LLC

-- Move upward to cut the window glass free.

-- Move the reel device as shown.

GWWA64-10383Courtesy of AUDI OF AMERICA, LLC

-- Cut the window glass free at the upper right window corner.

GWWA64-10384Courtesy of AUDI OF AMERICA, LLC

-- Move the window glass over to the left corner of the window and cut the window free.

GWWA64-10385Courtesy of AUDI OF AMERICA, LLC

-- Move the left reel device to approximately the center of the window as illustrated and mount the guide awl.

GWWA64-10386Courtesy of AUDI OF AMERICA, LLC

-- Cut the window free along the top to approximately the center of the window.

GWWA64-10387Courtesy of AUDI OF AMERICA, LLC

-- Move the right reel device over the left one as illustrated and cut free the window glass completely.

GWWA64-10388Courtesy of AUDI OF AMERICA, LLC

-- Lift the window out of the rear lid using the suction lifters.