Rear FOOTWELL Vent, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove The Sill Panel Strip. Refer to SILL PANEL, REMOVING AND INSTALLING .
-- Remove the front seat. Refer to OVERVIEW - FRONT SEAT / FRONT SEAT, REMOVING AND INSTALLING .
-- Remove The Front Belt End Fitting. Refer to FRONT BELT END FITTING, REMOVING AND INSTALLING .
-- Remove the center console. Refer to CENTER CONSOLE, REMOVING AND INSTALLING .
-- Loosen and lift the carpet in the vent area.
NOTE:
If necessary, remove the A-pillar trim panel and fold back the carpet as much as possible. Refer to CARPET, REMOVING AND INSTALLING .
-- Pry out the wire clip -3-.
-- Lift up the rear footwell vent -1- in direction of -B arrows-, move it off of the heater and A/C unit -2- in direction of -arrow A- and remove it to the side.