RECIRCULATION Door Motor -V113-, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install In Reverse Order Of Removal. Note The Following:

Tightening specification. Refer to OVERVIEW - HEATER AND A/C UNIT .

NOTE:

Check the function of the doors and linkage before installing.

Check if the lever and shafts are seated correctly in the mounts.

-- The fresh-air door must be set to "opened".

The actuating shaft -2- must contact the stop -1- -arrow- as illustrated.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

If the actuating shaft of the actuator is not set to "fresh-air mode" stop, turn the mount in the actuator. See notes. Refer to ACTUATOR .

-- Mount the actuator to the air intake housing so that the actuating shaft engages into the mount.

There must not be any play in the connection between the actuating shaft and the mount.

NOTE:

If the bolts cannot be installed, the actuator does not sit completely on the housing.

-- Install the wiring harness so that it cannot come in contact with any moving parts (for example, the lever on the actuator).

-- To check the actuator function, connect the adapter cable (refer to ACTUATOR ) or connect the actuator terminals "5" and "6" to a 12 V battery via a 5A fuse using a cable from the :VAG1594D .

NOTE:

Turn the actuator so far until it has reached a favorable position for installation. The direction of rotation can be reversed by switching the positive and negative.

-- Check the DTC memory and erase any displayed entries, then perform the "basic setting". Use the :Vehicle Diagnostic Tester in the "Guided Fault Finding" function.

-- Check the heater and A/C unit function.