Overview - Seat Position Sensor
WARNING: This page is about a different variant/trim than selected.
NOTE:
The Illustration Shows The Passenger Seat Position Sensor With The Wiring Harness.
- Coupling Connector
- Connector station in the vehicle floor under on the side sill under the seat.
- Cable Holder/Cable Tie
- Clip into the seat frame
- Coupling Connector
- For the Seat Belt Latch
- Cable Holder/Cable Tie
- Clip into the seat frame
- Seat Rail
- Tunnel-side
- Front Passenger Seat Position Sensor -G554-
- Driver seat: Driver Seat Position Sensor -G553-
- Removing and Installing. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING .
- Bolt
- 1.2 Nm
- Coupling Connector
- Only for the front passenger seat: for Passenger Occupant Detection System Control Module -J706-