Front Passenger Seat Occupant Detection Sensor -G128-, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

WARNING:

Follow all safety precautions when working on pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
Before handling pyrotechnic components (for example, connecting a connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
Follow all the instructions when installing the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

CAUTION:

The new passenger occupant detection sensor should be installed in the same location as the old sensor.

Install in reverse order of removal and Note The Following:

-- Push the clips for the passenger occupant detection sensor into the seat pan until they click into place.

NOTE:

Make sure the connectors are installed all the way and engage audibly.

If the Airbag Indicator Lamp -K75- indicates a fault after installing, check the DTC memory, erase it and check it again using the Vehicle Diagnostic Tester.