Passenger Occupant Detection System, Removing And Installing: Notes

WARNING: This page is about a different variant/trim than selected.

NOTE:

The passenger occupant detection system is only installed in the passenger seat.

WARNING:

The replacement part (Service Kit) for the passenger occupant detection system (market-specific version) is already pre-installed. Never disconnect the connector between the Passenger Occupant Detection System Control Module -J706- and the Front Passenger Occupant Detection Sensor -G128-. The service kit differs depending on the seat version and consists of:

Seat cushion with/without a seat heating element
Front Passenger Occupant Detection Sensor -G128- attached to the seat cushion
Passenger Occupant Detection System Control Module -J706-