Overview - Driver Side Airbag, Vehicles Through My 2016

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Driver Side Airbag

Courtesy of AUDI OF AMERICA, LLC

Locking Bracket
- Use a T25 TORX^® screwdriver, approximately 100 mm long
Steering Column Electronics Control Module -J527-
- with Spiral Spring -F350-
- Overview. Refer to OVERVIEW - STEERING COLUMN SWITCH MODULE, WITH ELECTRONIC IGNITION SWITCH .
4-Spoke Steering Wheel
- Equipped on some models
- Overview. Refer to OVERVIEW - STEERING COLUMN SWITCH MODULE, WITH ELECTRONIC IGNITION SWITCH .
Wiring Harness
- For the Driver Airbag Igniter -N95-
- Replacing. Refer to AIRBAG CONNECTOR, REPLACING .
- Press in to secure in the pockets on the steering wheel.
Driver Side Airbag
- With Driver Airbag Igniter -N95-
  WARNING:
  Follow all safety precautions when working on pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
- Removing and Installing. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING, VEHICLES THROUGH MY 2016 .
Bolt
- Tightening specification. Refer to STEERING WHEEL, REMOVING AND INSTALLING / OVERVIEW - STEERING WHEEL .
3-Spoke Steering Wheel
- Equipped on some models
- Overview. Refer to STEERING WHEEL, REMOVING AND INSTALLING / OVERVIEW - STEERING WHEEL .
Wiring Harness
- For the Driver Airbag Igniter -N95-
- Replacing. Refer to AIRBAG CONNECTOR, REPLACING .
- Press in to secure in the pockets on the steering wheel.
Driver Side Airbag
- With Driver Airbag Igniter -N95-
  WARNING:
  Follow all safety precautions when working on pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
- Removing and Installing. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING, VEHICLES THROUGH MY 2016 .
Bolt
- Tightening specification. Refer to STEERING WHEEL, REMOVING AND INSTALLING / OVERVIEW - STEERING WHEEL Steering .