Airbag Connector, Replacing: Installing
WARNING: This page is about a different variant/trim than selected.
WARNING:
- Follow all safety precautions when working on pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
- Before handling pyrotechnic components (for example, connecting a connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
- To prevent electrostatic charge, the technician must not leave the vehicle during the procedure.
-- Connect the connector -1- to the airbag igniter -arrow A-.
-- Press in the connector lock -2- -arrow B-. While doing this, the connector is pushed into the airbag igniter and locks into place.
Further installation is performed in reverse order of removal, while noting the following:
NOTE:
Make sure the connectors are installed all the way and engage audibly.