Overview - Steering Gear
WARNING: This page is about a different variant/trim than selected.
- Bolt
- 70 Nm + 90°
- Always replace if removed
- Subframe
- Power-Assisted Steering Gear
- There are different versions. Refer to the Parts information
- With integrated Power Steering Control Module -J500- and Steering Angle Sensor -G85-
- Check the Power Steering Control Module -J500- and Steering Angle Sensor -G85- in Guided Fault Finding Vehicle Diagnostic Tester
- The Power Steering Control Module -J500- and Steering Angle Sensor -G85- cannot be replaced separately. Replace the steering gear if faulty
- Steering gear, removing and installing. Refer to STEERING GEAR, REMOVING AND INSTALLING .
- Nut
- 20 Nm + 90°
- Counterhold on the tie rod end stud to prevent it from rotating when tightening
- Always replace if removed
- Right Wheel Bearing Housing
- Heat Shield
- Depending on the engine installed, there are different versions. Refer to the Parts information
- Bolt
- 6 Nm
- Depending on the engine installed, three or four are installed. Refer to the Parts information
- For securing the electrical wire
- Threaded Bushing
- Quantity: 2
- Electrical Wire
- Expanding Clip
- Steering Shaft with Universal Joint
- Bolt
- Tightening specification: -item 8- OVERVIEW - STEERING COLUMN
- Always replace if removed
- Clean the threaded hole (for example, using a thread tap) before installing the new bolt
- Seal
- Replace if damaged
- Left Wheel Bearing Housing
- Nut
- 20 Nm + 90°
- Always replace if removed
- Counterhold on the tie rod end stud to prevent it from rotating when tightening
- Bolt
- 70 Nm + 90°
- Always replace if removed