Individual Wire, Removing

WARNING: This page is about a different variant/trim than selected.

WARNING:

Follow all safety precautions when working on pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.

-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

-- Fasten the front seat on the :VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .

Courtesy of AUDI OF AMERICA, LLC

-- Remove the rear bracket for the wire routing from the seat pan with a screwdriver.

-- Separate the cable holder -2 and 5- and cable tie -3 and 4-.

NOTE:

-- Remove the individual wire from the protective cover -1-.

Modular Wire Routing:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the rear bracket for the wire routing from the seat pan with a screwdriver.

-- Remove the cable holder -3, and 5- for the corrugated tube, to do this open the bracket.

-- Remove the wire -2- from the corrugated tube -1 and 4-.

NOTE:

-- Cut through the cable tie and remove the individual wire.